memse 0 Report post Posted June 12, 2008 I have a 1995 296 which came back from a service without the thru-hull fitting on the bow which I believe is to drain the anchor locker. I didn't notice this for some time so it wasn't in the cards to get it back from the servicing center. What fitting size is this and does it need to be bedded with sealing compound? Any comments about what to use and installing would be appreciated. Share this post Link to post Share on other sites
The MOST 0 Report post Posted June 19, 2008 The factory installed anchor locker thru hull was 3/4" in diameter. You can purchase these at any marine supply store. It is best to use a marine grade adhesive/sealant when re-installing. Share this post Link to post Share on other sites
