Jump to content
My Monterey
Sign in to follow this  
JAVADO

2006 322 GROUND

Recommended Posts

AT THE REAR INSIDE THE ENGINE ROOM JUST UNDER THE TRIM FLAP CILINDER CONNECTIONS ARE BOLDS INBEDDED AND WIRED TO THE CENTER OF THE SAME BACK SIDE WHERE A SIMILAR BOLD IS. FROM THAT CENTER I HAVE ONE LOOSE WIRE HANGING.

 

 

CAN M.O.S.T EXPLAIN WHY ARE THESE HOOKUPS INSTALLED AND WHERE SHOULD I HOOKUP THE LOOSE WIRE?

 

THANKS

 

JAN VAN DOORN

SANTO DOMINGO, DOMINICAN REPUBLIC

Share this post


Link to post
Share on other sites

HI again!

JIM here!!! I just read and responded to your post re: your holes in your stainless props. Then I read this "Problem". Sounds to me like solving this wiring problem my may also have something to do with the electrolysis situation.

Good Luck

 

JIM Vero Beach, Fl, USA

Share this post


Link to post
Share on other sites
HI again!

JIM here!!! I just read and responded to your post re: your holes in your stainless props. Then I read this "Problem". Sounds to me like solving this wiring problem my may also have something to do with the electrolysis situation.

Good Luck

 

JIM Vero Beach, Fl, USA

 

 

Jim,

 

Thanks a lot for your information. I am in the Dominican Rep and hope I can find an experienced electricien, which I doubt. I have to resolve the problems myself. Did you eventually resolve yours?

 

Jan, Santo Domingo

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...