DWE 0 Report post Posted February 26, 2009 I have a 2004 265 CR and the only a minimal amount of water is being dischaged. Does the seawater pump have a impellar similar to the one in the Kohler gen set? I have checked the strainer and everything is clear. not cooling properly as not enough water is being pumped through. any advice most appreciated Share this post Link to post Share on other sites
Ian 0 Report post Posted March 8, 2009 Hi, Looking at the General Use, Care and Maintenance Manuals section of the board Under Marine Air Vector series model VCD5 thru VCD24 page 15 says "... the seawater pump utilizes a magnetically driven impeller..." Not sure what you have done to investigate so far but I would check for blockages of the pickup and all pipes (not just in the strainer) You should be able to locate the pump model / serial number on the pump body. Also see if it lists the flow rate of the pump (gallons per hour) and measure. If not, try to track down more info and parts etc. through www.dometic.com. Hope this helps Share this post Link to post Share on other sites
DWE 0 Report post Posted March 9, 2009 Thanks Ian. I will investigate further Share this post Link to post Share on other sites
