JAVADO

Jim, Thanks a lot for your information. I am in the Dominican Rep and hope I can find an experienced electricien, which I doubt. I have to resolve the problems myself. Did you eventually resolve yours? Jan, Santo Domingo

I HAVE A 2006 322 AND AFTER THREE YEARS USE, DURING THE YEARLY MAINTENANCE, I FOUND HOLES IN MY PROPS. SEE PICTURES. THE BOAT IS MOORED CONSTANTLY IN SEAWATER. I EXCHANGE EVERY YEAR ALL THE ANODES ON THE DRIVES, THE ROUND ONES AT THE BOTTOM OF THE DRIVE AND THE TOP DRIVE ANODES, THE TRIANGULAR ON THE HYDRAULIC TILT CILINDERS. QUESTIONS: 1. WHAT IS CAUSING THIS WEAR IS THIS ELECTROLYSE? 2. HOW CAN I PREVENT THIS? 3. CAN I PAINT THE PROPS WITH 2 COMPONENT EPOXY TO PREVENT THIS? 4. CAN THESE PROPS BE REPAIRED? THANKS, JAN VAN DOORN, SANTO DOMINGO, DOMINICAN REPUBLIC

AT THE REAR INSIDE THE ENGINE ROOM JUST UNDER THE TRIM FLAP CILINDER CONNECTIONS ARE BOLDS INBEDDED AND WIRED TO THE CENTER OF THE SAME BACK SIDE WHERE A SIMILAR BOLD IS. FROM THAT CENTER I HAVE ONE LOOSE WIRE HANGING. CAN M.O.S.T EXPLAIN WHY ARE THESE HOOKUPS INSTALLED AND WHERE SHOULD I HOOKUP THE LOOSE WIRE? THANKS JAN VAN DOORN SANTO DOMINGO, DOMINICAN REPUBLIC