Head vacuum problems

[Head vacuum problems]

15 February 2017

 

I own a 2002, 322 Cruiser. The vacuum motor would not stop pumping and no vacuum build up with water in bowl. I could not find a switch that would could turn it off. I found the circuit breaker in the cockpit next to the battery switches on the port side and finally disconnected one side termianl. That stopped the pump.

 

I understand the system and what the potential issues could be. What I do not know is how to access the pump, the reservoir, duck bills and everything else related to the system. Everything is located on the port side behind the panel and a small closet located aft.

 

Before I begin exploring does anyone know for sure how to access the system or have diagrams?

 

Thanks,

 

 

[Snap in Carpet replacement - best source]

I would suggest you look into "Sea Dek". (seadek.com) I have switched to this product and have had it installed for two years now. Awesome!

[2003 322 Cruiser VacuFlush Pump Location]

I found the circuit breaker for the pump. It is adjacent to the battery switches in the cockpit on my vessel. No switch, so I disconnected the wires from the circuit breaker and this shut off pump. Now.............Has anyone actually found the location of the pump on the Monterey cruisers. Do I need to remove the closet, the wall or what?.

 

Thanks,

[Vacu Flush circuit breaker]

I own a 2002 -322 Cruiser.

 

Vacu Flush tends to run continuously sometimes.

 

I cannot locate a fuse or breaker anywhere. The circuit breaker panel DOES NOT have a breaker like the manual shows.

 

I have searched the wiring diagrams and the boat trying to trace the wiring and cannot seem to find the breaker.

 

Anybody have any suggestions?

 

thanks,

[2003 322 Cruiser VacuFlush Pump Location]

Have you found the pump?

 

My 2002 model has the same issue. I have been told it is behind the closet next to the head.

[2002 322 Part Numbers]

I own a 2002 , 322 cruiser and experienced the same issue with the windshield screw cover. I measured the channel width and then relied on the internet to locate a molding that works. Look up Sea Ray and Bayliner windshield screw cover molding, I believe the channel is 1 " wide, but you will need to measure. Looks great after replaced!

 

Good luck