Bilge pumps in cabin floor

[Bilge pumps in cabin floor]

Mine had a circuit breaker for the bilge pumps at the Main battery switch panel.

[Serpentine belt alignment 2007 Cr250 Volvo 5.7L]

I  cannot comment on your balancer and crank pully if it is different.

I had to break out the long straight edge and start lining up the pulleys. I found that the large bracket for the power steering needed to be shimmed with washers at the very bottom to get the the angle right. I found that the pully were more radially relative to each other than in or out (depth to the front of the engine) from the crank pulley.

After shimming the mounting bracket there is considerably less black rubber dust and zero squeaking.

[Windlass won’t come up]

If you have the Simpson Larwence sprint 600 as I did on my 2004 298SC there is no solenoid. it has a circuit breaker by your shins at the helm and runs off the windlass switch.

there is internal parts in the windlass that break and cause the problem, besides just being worn out and old. You can take it apart and fix it but it will break again soon  and will be week. I did this and it ended up being a waste of time even though I did get it to work.

If you install a larger windlass you need a solenoid and bigger cable. the bigger cable may be installed in the anchor locker already but good luck finding the other end. (  could never locate it) A larger windlass will also require a heavier chain and rhode.

I installed a new Lewmar 700 windlass as a direct replacement and it works great and is stronger. Make VERY water tight wire connections in the anchor locker.

[constant beeping sound]

Push the button on the depth finder to stop the noise

[Monterey 322 Head shower faucet replacement]

Did you try and remove the toilet paper holder?

[prop selection for 298 ??]

My 298 with 5.0 GXI has F6 props. There is no way it is going to go 60MPH  be happy with 50 mph and some good fuel range.

[2004 298 SC step down well drain clogged]

My step down well into the cabin drain is clogged.

I have tried to clear with both compressed air and the garden hose. I even put a fish tape down it and it stops just after the hose disappears behind the bulkhead at the rear of the shower/Forward bilge well.

Can anyone or MOST tell me where this hose routes to? Or how to access it? Its under the main deck floor.

Does it rout the the engine compartment? where can I find the other end? It is completely sealed so it appears it is being pinched by something.

[Windlass wires 2000 276]

A windlass switch would be near the shifters at the helm, there would also be a large circuit breaker at the helm for the winch start looking there first since the polarity for the red and black wire changes at the switch.

[Zoheir Bangali]

start by replacing the radiator cap and make sure raw water pump is moving water through the heat exchanger.

[2005 298SC Anchor/Docking lights.]

If you sand it well and use silver paint is may be a big improvement for the price of a can of paint.