JAVADO 0 Report post Posted July 7, 2009 AT THE REAR INSIDE THE ENGINE ROOM JUST UNDER THE TRIM FLAP CILINDER CONNECTIONS ARE BOLDS INBEDDED AND WIRED TO THE CENTER OF THE SAME BACK SIDE WHERE A SIMILAR BOLD IS. FROM THAT CENTER I HAVE ONE LOOSE WIRE HANGING. CAN M.O.S.T EXPLAIN WHY ARE THESE HOOKUPS INSTALLED AND WHERE SHOULD I HOOKUP THE LOOSE WIRE? THANKS JAN VAN DOORN SANTO DOMINGO, DOMINICAN REPUBLIC Share this post Link to post Share on other sites
JRSto 0 Report post Posted July 13, 2009 HI again! JIM here!!! I just read and responded to your post re: your holes in your stainless props. Then I read this "Problem". Sounds to me like solving this wiring problem my may also have something to do with the electrolysis situation. Good Luck JIM Vero Beach, Fl, USA Share this post Link to post Share on other sites
JAVADO 0 Report post Posted July 16, 2009 HI again! JIM here!!! I just read and responded to your post re: your holes in your stainless props. Then I read this "Problem". Sounds to me like solving this wiring problem my may also have something to do with the electrolysis situation. Good Luck JIM Vero Beach, Fl, USA Jim, Thanks a lot for your information. I am in the Dominican Rep and hope I can find an experienced electricien, which I doubt. I have to resolve the problems myself. Did you eventually resolve yours? Jan, Santo Domingo Share this post Link to post Share on other sites
