timh8000 0 Report post Posted August 4, 2008 Has anyone figured out how to add a small cockpit table in front of the back seat on a 298 ss. Ideally, I would like to avoid drilling/cutting and just use the existing hole where there is a latch to open and close/lock the storage under the drivers side. The only problem with replacing the latch is that a simple table base won't keep the storage area locked down. Any thoughts? Share this post Link to post Share on other sites
ErikS 0 Report post Posted September 1, 2009 Has anyone figured out how to add a small cockpit table in front of the back seat on a 298 ss. Ideally, I would like to avoid drilling/cutting and just use the existing hole where there is a latch to open and close/lock the storage under the drivers side. The only problem with replacing the latch is that a simple table base won't keep the storage area locked down. Any thoughts? I just bought an 03 298 SS and I'm also interested in installing a table. any suggestions from MOST or anyone else? Thanks! Share this post Link to post Share on other sites
timh8000 0 Report post Posted September 29, 2009 <!--quoteo(post=1081:date=Aug 3 2008, 10:08 PM:name=timh8000)--><div class='quotetop'>QUOTE(timh8000 @ Aug 3 2008, 10:08 PM) <a href="index.php?act=findpost&pid=1081"><{POST_SNAPBACK}></a></div><div class='quotemain'><!--quotec-->Has anyone figured out how to add a small cockpit table in front of the back seat on a 298 ss. Ideally, I would like to avoid drilling/cutting and just use the existing hole where there is a latch to open and close/lock the storage under the drivers side. The only problem with replacing the latch is that a simple table base won't keep the storage area locked down. Any thoughts?<!--QuoteEnd--></div><!--QuoteEEnd--> I just bought an 03 298 SS and I'm also interested in installing a table. any suggestions from MOST or anyone else? Thanks! I found a spot to install the table. You need to put the pole in the aft starboard part of the boat AND you need a pole that bends at a 90 degree angle to support the table (this allows for the pole to be pretty much out of the way of people sitting). Watch placement so that you can open the rear seat for access to the cooler. Share this post Link to post Share on other sites
Rip5 0 Report post Posted April 5, 2012 Old thread, but since I will be adding a table to our new 204FS, here is what I am getting. Factory table is round, and I prefer the oval table. Factory set up is $450, this one is only $258 complete. Share this post Link to post Share on other sites