Swolle 0 Report post Posted October 13, 2014 All, Again I'm new to Boats and I bought mine (Monterey 250 CR from 2007) from a private owner.. (so not much instructions).. I'm now going to take my boat out of the water to have it stored for the winter. I noticed that after it has been taken out of the water I should remove the bilge drain plug immediately.. where do I find this "plug"? Thanks for your assistance :-). BR Swolle Share this post Link to post Share on other sites
Indy Steve 0 Report post Posted October 15, 2014 All, Again I'm new to Boats and I bought mine (Monterey 250 CR from 2007) from a private owner.. (so not much instructions).. I'm now going to take my boat out of the water to have it stored for the winter. I noticed that after it has been taken out of the water I should remove the bilge drain plug immediately.. where do I find this "plug"? Thanks for your assistance :-). BR Swolle On the back of the boat at the lowest point. Share this post Link to post Share on other sites
Rip5 0 Report post Posted October 16, 2014 "Where do I find this plug?" Seriously ??? It's directly under the sterndrive, at the lowest point of the transom. Share this post Link to post Share on other sites
Heinrich 0 Report post Posted October 16, 2014 It's located on the stern (at the lowest point, about 1 inch up). Usually made from copper. Now, if you live in Florida, this is likely all you need to do, however if you are up north... you may want to start to research how to winterize the engine and/or any water tanks (or 1st time I suggest you get someone to show you how easy it is, so that you can do it yourself next time). Taking out the bilge plug is just to drain any water in the bilge (this does not winterize the boat). Share this post Link to post Share on other sites
Swolle 0 Report post Posted November 17, 2014 Thanks everybody :-). I'm new to this and I found it.. :-). Swolle Share this post Link to post Share on other sites
