Jump to content
My Monterey


  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About jfed

  • Rank
  1. Anyone figure this out I also need access to the sender.
  2. I'm not with my boat at the moment but I glued the one that holds it up back. I used this SCIGRIP 16 10315 Acrylic Cement, Low-VOC, Medium bodied, 5 Ounce Tube, Clear https://www.amazon.com/dp/B003HNFLMY/ref=cm_sw_r_cp_apap_AjHTAvSa2gGer
  3. Good marine supply should have the screws you need. Custom shop can help with your bimini. I'm not sure where you are located but usually there are plenty in a port town.
  4. This just tells you the hours meter is running.
  5. Quick question. How much line are you able to comfortably able to fit in the anchor locker with the windlass. From what I read you need a 12" drop to prevent tangles.
  6. Thank you, size still looks a bit off but I will look into it.
  7. Anyone have luck with that part number? I called and had no luck. They could not find any part number like that. I need the plastic trim but I would be willing to buy the whole thing. I have a broken locking tab and I don't want a leak. Thank you, Josh
  8. Anyone have an update part number I called Bromar and they don't have the part number.
  9. jfed

    Engine temp

    Sounds like the thermostat is stuck open.
  10. The gas spring hight on the trunk of my 245 CR seems a bit short. I wonder if the owner replaced it with the wrong size. Anyone know the right size, or does this look right?
  11. Thank you Brian, I'll take a look. It does look bent in the picture but I never noticed in person. I'll double check when I'm home.
  12. Yes, the picture is from summer as the boat is not in the water in the winter. That pic is after a quick rain storm. I'll check Umbrella's website for a local dealer.
  13. Thanks, I tried and I just can't seem to get it right. I'll test again.
  • Create New...