Lake Mead Monster 0 Report post Posted January 30, 2014 I wanted to repair and/or replace the faucet stems on my 2004 298 SC. I pulled all five stems (2 in kitchen, 2 in bath and one on sink near ice container). Here are my questions. 1. Can I not just replace the rubber washer on the bottom of the stem to improve the seal? You would think so but it appears you cannot remove that "screw" holding it on. There is a small impression on the "screw" but it appears to be nothing you can put a tool in to remove. 2. Where can I purchase all new faucet stems for my boat? I tried Lowes, Home Depot, West Marine, Plumbing Store and called a camper/RV shop with no luck. I'm not even sure the make of the plumbing fixtures the stems came out of. If it helps I can attach pictures of the stems or the hardware the stems were pulled from. Thanks in advance for your help. Quote Share this post Link to post Share on other sites
Rip5 0 Report post Posted January 31, 2014 Try here . Scandvik makes quite a bit of the marine fixtures in boats. Or here Hope you can find what you need. Quote Share this post Link to post Share on other sites
eightbells 0 Report post Posted January 31, 2014 our nozzle sprayers broke over the winter (i forgot to remove them) but i was able to purchase them at the local marina ships store. try that. Quote Share this post Link to post Share on other sites
Lake Mead Monster 0 Report post Posted February 17, 2014 I learned the washer at the end of the valve stems pry on and off. Called Scandvik and they mailed me all new washers and we are good to go. Thanks. Quote Share this post Link to post Share on other sites
GetAway 0 Report post Posted February 22, 2014 Try here . Scandvik makes quite a bit of the marine fixtures in boats. Or here Hope you can find what you need. Good leads, thanks for posting! Quote Share this post Link to post Share on other sites